SL2000高速數據采集單元是一種用于嵌入式系統的隔離示波器/高速數據采集器。

可以使用與DL950和DL350相同的插件模塊。

只需一個SL2000單元，您就可以同時記錄從低電壓到1000V的隔離模擬信號、數字信號、編碼器信號、來自車載網絡的CAN/CAN FD/LIN/SENT通信信號以及振動、應變和溫度等NVH信號。

高達200 MS/s

隔離1000 V輸入，7000 V輸入，帶差分探頭

高達8 G點內存

高達160 CH*（5個單元連接并同步）

*使用720221 16通道模塊時最多640通道

10 Gbps PC流

實時計算/功率計算/電機dq分析

Two operation modes: oscilloscope and recorder

There are two modes, "Scope Mode" and "Memory Recorder Mode", to suit the environment and purpose.

Scope Mode

• This is an operation mode suitable for measuring high-speed signals and repetitive waveforms.

• Like an oscilloscope, the waveform is recorded each time a trigger occurs according to the set time axis setting (T/Div) and number of sampling points.

• The measurement range is displayed in scale units (V/Div).

Memory Recorder Mode

• This is an operation mode suitable for measuring continuous waveforms over long periods of time.

• Like a data logger or recorder, it performs one-shot measurements with predefined measurement conditions, and records input signals by setting the sampling interval and recording time.

• The measurement range is displayed relative to the full width (upper and lower limits).

Maximum 200 MS/s, isolated 1000 V input. Up to 7000 V possible with differential probe

High-speed sampling of up to 200 MS/s 14 bits is possible, allowing you to accurately capture switching waveforms of high-speed inverters and rapid noise around power supplies.
In addition, when combined with a large-capacity memory of up to 8 G points, you can record continuously for up to 20 seconds even at high-speed sampling of 200 MS/s.

• The 720212 can provide isolated 1000V input when combined with the 700929 (10:1) /702902 (10:1) /701947 (100:1) passive probes.

• The 701255 High-Speed 10MS/s 12-Bit Non-Isolated Module or Isolated Module can be combined with the 701905 Conversion Cable and 701977 High-Voltage Differential Probe to measure high voltages up to 7000V.

Action on trigger and GO/NO-GO judgement

The Action on Trigger function automatically performs predefined tasks-such as saving data files, activating a buzzer, or sending notifications-when a trigger condition is met. Additionally, it can perform pass/fail (GO/NO-GO) evaluations based on waveform parameters such as shape or amplitude, and execute actions based on the result.